xxxxxxxxxx
# 1. Verify the remote URL
git remote -v
# Make sure the remote URL is correct. If not, update it with the appropriate remote repository URL using the following command:
git remote set-url origin <new_remote_url>
# 2. Check for any network issues
# Ensure your internet connection is stable and not causing any disruptions. Try running the following command to check the connectivity:
ping <remote_host>
# 3. Increase the Git buffer size
# Sometimes, increasing the Git buffer size can help alleviate this issue. Set the buffer size to a higher value using:
git config --global http.postBuffer <buffer_size_in_bytes>
# 4. Retry the push with a higher verbosity level
# By running the push command with a higher verbosity level, you can obtain more detailed error information, which might be useful in troubleshooting the issue.
git push -v
# 5. Configure Git to use HTTPS instead of SSH
# If you are using SSH to connect to the remote repository, you can try switching to HTTPS as some network configurations might block SSH connections.
git config --global url."https://".insteadOf git://
# 6. Disable SSL verification (not recommended, use only for troubleshooting)
# In some cases, temporarily disabling SSL verification can help identify if the local SSL certificates are causing the issue. Proceed with caution when using this solution.
git config --global http.sslVerify false
# After trying these solutions, attempt to push your changes again.
xxxxxxxxxx
//use this before git push -v origin master
git config --global http.postBuffer 100000000
// if one time cannot push still apperance this error: the remote end hung up unexpectedly
// use one more until you can git push, enjoy :D
git config --global http.postBuffer 100000000
git config --global http.postBuffer 100000000
git config --global http.postBuffer 100000000
xxxxxxxxxx
git remote remove origin
git remote add origin https://gitlab.com/your-page/your-page.git
xxxxxxxxxx
//fatal: the remote end hung up unexpectedly
//Run this command
git config http.postBuffer 524288000
the remote end hung up unexpectedly
xxxxxxxxxx
# update the buffer and speed limit
git config --global http.postBuffer 524288000 && \
git config --global http.lowSpeedLimit 0 && \
git config --global http.lowSpeedTime 999999
xxxxxxxxxx
# update buffer and speed limits
git config --global http.postBuffer 524288000 && \
git config --global http.lowSpeedLimit 0 && \
git config --global http.lowSpeedTime 999999